Below is a basic overview of the hardware that was set up and used for my Satellite Tracking activities at University!

STAC station at Strathclyde University is a student-driven experiment into low power, low cost Satellite communications for academic research purposes.

The station is also closely linked with WoSARS, who have been very supportive in the initial stages of the set up.

Currently the only person licensed to operate from the station is Dave, MM3ZRZ.

Hardware

Radio

The station is centred around an ICOM IC-910, the classic satellite tracking radio, with a satellite mode built in and dual band capability. There is a Yaesu FT817 as a back up radio.

TNC

Data communications at the Station are controlled by a Kantronics KAM for 1200baud, and a TNC31S is currently being implemented for 9600baud communication.

Both these TNCs are used for AFSK communications with satellites, and have been thoroughly tested with local packet communications and regular communications with the ISS.

Rotators

Controlling our antennas' direction is a pair of M2 RC2800PX - one for AZ and a second for EL.

Antennas

On top of the station, located on the University roof, we have two sets of stacked Yagi antennas for extra sensitivity. For 144MHz, we have two M2 2MCP14, and for 430MHZ we have two M2 436CP30.

For those who are interested, here is a picture (3MB) of the antennae on install day, supervised by one of the undergraduates who helped with the construction.

These are driven by a set of SSB Preamps, with DCW2004B sequence controllers in the Control Room.

All this is powered by a Diamond GZV6000 power supply, and a computer to controll all our operations from!

Software

Satellite Tracking

Tracking is currently accomplished using Nova for Windows, one of the few programs properly compatable with the rotator controllers. Plans are to move towards using GPredict as the main tracker, due to improved layout, shorter learning curve and the fact it is free & open. Also in the works is a new rotator controller to interface with this, and hopefully radio control also.

APRS

APRS, the Automatic Packet Reporting System is used for communication with other Radio Amateurs via the ISS, and also reports our location. The software used to accomplish this is AGWTracker in conjunction with AGWPacketEngine to interface with the TNC. This gives us the display of stations and their location, as well as incoming messages and lets us put out the status and link to the blog!